The 3/4" x 3/4" x 1/2" Compression Reducing Tee is the industry standard for branching a standard 1/2" line off a high-capacity 3/4" header. This configuration allows you to maintain high volume flow along your main perimeter (using 3/4" tubing) while dropping down to manageable 1/2" lateral lines for your garden rows or raised beds. It is an essential component for designing efficient, multi-zone irrigation systems.
Engineered for durability, this fitting uses internal compression rings to secure the tubing without the need for glue or clamps. As one of our most robust irrigation fittings, it ensures a permanent, leak-proof connection that can withstand the rigors of outdoor exposure and pressure fluctuations.
Verify tubing sizes before installation.
| Specification | Details |
|---|---|
| Product Type | Reducing Tee (Compression) |
| Run Connections (Ends) | 3/4" Compression (Fits .940" OD Tubing) |
| Branch Connection (Middle) | 1/2" Compression (Fits .700" OD Tubing) |
| Operating Pressure | 0 - 60 PSI (Optimal: 20-30 PSI) |
| Material | High-Impact ABS Plastic |
| MPN | RCT 997 |
Install this reducing tee without tools.
Step 1: Prep the Tubing
Cut both your 3/4" and 1/2" tubing with clean, square ends.
Pro Tip: Compression fittings are very tight. Allow the tubing to warm in the sun or dip the ends in hot water to soften them significantly before insertion.
Step 2: Connect the Run (3/4")
Push the 3/4" tubing into the straight-through ends of the tee. Rock the tubing back and forth while pushing firmly until it passes the internal compression ring (approx. 3/4" deep).
Step 3: Connect the Branch (1/2")
Insert the 1/2" tubing into the center branch port. Push firmly until it seats fully against the internal stop.
Ensure the sizes match your system:
Get all the compatible parts for your layout:
Nov 12th 2026
Nov 11th 2026
Nov 10th 2026
Nov 9th 2026
