The Automatic Flush Valve is a self-cleaning device designed to purge debris from your drip irrigation lines at the start and end of every watering cycle. By installing this valve at the end of your mainline or drip tape rows, you allow a small burst of water to flush out fine sediment before the system pressurizes and seals. This simple addition works in tandem with your system filter to prevent clogged emitters and extend the life of your setup.
Available in both Hose Thread (VFH) and Pipe Thread (VFP) configurations, these are essential irrigation fittings for low-maintenance systems. Whether you are running a home garden on standard poly tubing or a commercial field, adding a flush valve ensures that dirt settling in the lines is expelled automatically, saving you the manual labor of opening end caps.
Choose the correct thread type for your system.
| Specification | Details |
|---|---|
| Product Type | Automatic Flush Valve |
| Operating Pressure | Closes at ~2 PSI (Opens when pressure drops) |
| MPN (Hose Thread) | A2-FVFHTH (Often used on 1/2" Systems) |
| MPN (Pipe Thread) | A2-FVFPTH (Often used on 3/4" Systems) |
| Material | High-Impact Plastic / Rubber Diaphragm |
| Common Brand Names | Irritec |
These valves are installed at the lowest point or the very end of your irrigation zone. Select your model below for specific connection parts:
Note: Ensure the valve is oriented correctly (water flows out of the bottom ports). Do not overtighten.
Double-check before buying:
Required parts for installation:
May 20th 2026
May 19th 2026
May 18th 2026
May 14th 2026
