The Hose x 1/4" Barb Adapter is the essential starting point for any small-scale patio or container drip system. This fitting allows you to connect 1/4" micro-tubing directly to a standard outdoor faucet, garden hose, or hose thread timer. It effectively bridges the gap between high-volume water sources and precision emitters.
Whether you are setting up a single window box or a series of potted plants, this is one of the most versatile irrigation fittings for your drip hose or supply line run without the need for bulky manifold assemblies or expensive PVC conversions.
Ensure this adapter matches your existing faucet and tubing size.
| Specification | Details |
|---|---|
| Inlet Type | 3/4" Female Hose Thread (FHT) |
| Outlet Type | 1/4" Barb (Fits .170" ID Tubing) |
| Compatible Tubing | 1/4" Poly or Vinyl Micro-Tubing |
| Material | UV-Stabilized Polypropylene |
| Sealing Mechanism | Rubber Hose Washer (Included) |
| MPN | FHA-250 |
| Manufacturer | NDS |
Step 1: Check the Washer
Ensure the rubber hose washer is seated flat inside the female threads of the adapter before attaching it to the faucet.
Step 2: Connect the Tubing
Push your 1/4" poly tubing over the barb. For an easier fit, dip the end of the tubing in warm water for a few seconds to soften it before sliding it onto the barb.
Step 3: Hand Tighten
Thread the adapter onto your faucet or timer. Tighten it by hand until firm. Do not use a wrench, as over-tightening can damage the plastic threads or compress the washer too far.
Step 4: Flush the Line
Turn on the water briefly to flush out any debris from the tubing before attaching your drippers or misters.
Standard Threads vs. Pipe Threads:
Pair this adapter with these essential components for a complete micro-drip setup:
May 28th 2026
May 27th 2026
May 26th 2026
May 21st 2026
