The Schedule 40 PVC 45° Elbow (Slip x Slip) is designed to change the direction of your pipe run by 45 degrees, offering a much smoother transition than a sharp 90-degree turn. By reducing turbulence and friction loss, this fitting helps maintain higher water pressure throughout your system. It is one of the most critical irrigation fittings for routing lines around garden beds, trees, or structural obstacles where a hard angle isn't necessary.
Manufactured from durable white Schedule 40 PVC, this elbow features two socket ends that fit over standard PVC pipe. It requires a solvent weld connection using Blue Hot PVC Glue and primer, creating a permanent, fused joint that is as strong as the pipe itself.
Detailed specs for system compatibility.
| Specification | Details |
|---|---|
| Product Type | 45° Elbow |
| Connection Type | Slip x Slip (Socket x Socket) |
| Material | Schedule 40 PVC (White) |
| Operating Pressure | Varies by size (Exceeds standard irrigation pressures) |
| Standards | ASTM D-1784, ASTM D-2466, NSF Approved |
| MPNs |
417-005 (1/2"), 417-007 (3/4"), 417-010 (1") |
A proper solvent weld is critical for a leak-free system.
Step 1: Cut & Prep
Cut your PVC pipe square and remove any burrs. Clean the outside of the pipe and the inside of the fitting socket.
Step 2: Prime
Apply Purple Primer to both the pipe end and the fitting socket. This softens the plastic for bonding.
Step 3: Glue
While the primer is still wet, apply a coat of PVC Glue to the pipe and the fitting. Push the pipe fully into the socket, twisting a quarter turn to distribute the cement.
Step 4: Hold
Hold the joint together firmly for 30 seconds to prevent "push-out" as the chemical weld sets.
Ensure this fits your pipe:
Get everything you need for a professional installation:
May 13th 2026
May 12th 2026
May 11th 2026
May 7th 2026
