Multi-Outlet Dripper Assembly (DMWASS) for Woodpeckers

Water four containers from a single emitter in minutes.

Step 1: Punch and Insert the Emitter
Punch a hole in your 1/2" or 3/4" mainline tubing and insert a Woodpecker or Woodpecker Jr. emitter.

Step 2: Attach the Assembly
Push the inlet of the DMWASS Multi-Outlet Assembly firmly onto the outlet barb of the emitter until it is fully seated.

Step 3: Position the Drippers
Route each of the four pre-attached tubes (two 18" and two 30") to its container, placing the arrow dripper at the base of the plant.

Step 4: Expand if Needed
To water up to eight containers, push a DMWST Stackable Assembly onto the emitter outlet first, then attach the DMWASS Flat Assembly to the stackable unit.

How many containers can this assembly water?
The DMWASS Flat Assembly on its own waters four containers from a single Woodpecker or Woodpecker Jr. emitter.

Add the DMWST Stackable Assembly to the same emitter to expand coverage to eight containers total.

How much water will each container receive?
Each of the four outlets receives one-quarter of the emitter's rated flow. For example, a 1 GPH Woodpecker emitter supplies each container with 1/4 GPH.

Because flow is divided evenly across all outlets, choosing an emitter with a higher GPH rating is often recommended to ensure each container receives adequate water.

Does this assembly include the emitter?
No, the Woodpecker or Woodpecker Jr. emitter is sold separately and must be purchased in addition to this assembly.

The assembly is designed to push directly onto the outlet barb of either emitter type.

What do I do if I temporarily stop using an emitter?
Remove the Multi-Outlet Assembly and cap the emitter outlet with a Woodpecker Shutoff Cap to stop water flow.

This is a handy option in nurseries and greenhouses where plants and containers are moved or sold on a rotating basis.