Elbow Mister (5 Pack)

Build your directional cooling or humidity system with ease.

Step 1: Prep Your Supply Line
For directional misting, run 1/4-inch micro tubing from your primary 1/2-inch mainline to the specific plant or area you want to cool.

Step 2: Insert the Elbow Mister
Take the Elbow Mister and push its 1/4-inch barbed end directly into the open end of your 1/4-inch micro tubing. Push firmly until it is fully seated.

Step 3: Position the Spray
Use a stake, clip, or wire tie to secure the micro tubing. Rotate the tubing or the mister head to point the spray pattern exactly where you need humidity or cooling.

Step 4: Verify System Pressure
Turn on your water supply. Ensure your system pressure is regulated high enough—between 35 and 80 PSI—to properly atomize the water into a fine fog.

Are the Elbow Misters good for cooling spring greenhouses?
Yes, the Elbow Misters are highly effective for greenhouse cooling. Their ultra-fine 50-100 micron droplets evaporate rapidly, safely reducing temperatures inside enclosed structures during the warm spring and summer months.

They are also perfect for providing a localized, high-humidity microclimate for moisture-loving tropical plants and orchids.

How do I install the Elbow Misters for directional spraying?
To utilize the directional feature, push the 1/4-inch barbed elbow directly into the end of a flexible 1/4-inch micro tubing line. You can then twist the tubing to aim the mist precisely.

What water pressure is needed for the Elbow Misters?
Like all true foggers, the Elbow Misters require higher pressure to atomize water properly. They operate optimally between 35 and 80 PSI. Do not use low-pressure drip regulators with this product.

Will the Elbow Misters soak the soil in my potted plants?
No, these are extremely low-flow misters emitting just 1.5 GPH. When run at the correct pressure (35+ PSI), the mist primarily stays suspended in the air to boost humidity without drowning the soil.