Buy 50 or above and get 8.21% off
The 3/4" Compression Male Hose End Cap is the definitive solution for closing off the end of a high-capacity drip line. This assembly combines a heavy-duty compression adapter with a removable hose cap, allowing you to seal your 3/4" mainline tubing securely while retaining the ability to open the system for maintenance.
Regular flushing is critical for long-term system performance, and this fitting makes it simple. By unscrewing the cap, you can purge debris, sediment, and mineral buildup that might otherwise clog your emitters. As one of our most practical irrigation fittings, it ensures your large-scale system remains clean and operational year after year.
Key specs for your system end point.
| Specification | Details |
|---|---|
| Product Type | Compression End Cap Assembly |
| Connection 1 | 3/4" Compression (Fits .940" OD Tubing) |
| Connection 2 | 3/4" Male Hose Thread (MHT) with Cap |
| Operating Pressure | 0 - 60 PSI (Optimal: 20-30 PSI) |
| Material | High-Impact ABS Plastic |
| Manufacturer | NDS |
| MPN | CEP 900 |
Install in minutes for a clean finish.
Step 1: Prep the Tubing
Cut the end of your 3/4" poly tubing squarely. Ensure the cut is clean and free of burrs.
Pro Tip: 3/4" tubing is stiff. Warm the end in the sun or hot water for 10-20 seconds to soften it before installation.
Step 2: Connect the Adapter
Push the tubing into the compression end of the fitting. Rock it back and forth while pushing firmly until it passes the internal resistance ring (approx. 3/4" deep).
Step 3: Secure the Cap
Ensure the hose washer is inside the cap, then screw the cap onto the threaded end. Hand-tighten until snug. Unscrew periodically to flush the line.
Ensure this fitting matches your components:
Essential components for a professional installation:
Jan 22nd 2026
Jan 21st 2026
Jan 20th 2026
Jan 19th 2026
