The 1/2" Compression Female Hose Start Elbow is the ideal starting point for a drip system that connects to a faucet, hose bibb, or garden hose. This fitting features a swivel 3/4" Female Hose Thread (FHT) connection, allowing you to attach it securely to your water source or pressure regulator without twisting your entire line of tubing.
By orienting your 1/2" poly tubing at a 90-degree angle immediately after the connection, this elbow prevents kinking and allows for a neat, organized layout against a house wall or raised bed. As one of our most essential irrigation fittings for head assemblies, it utilizes a secure compression ring to grip the tubing for a permanent, leak-proof seal.
Key details for your head assembly.
| Specification | Details |
|---|---|
| Product Type | Female Hose Start Elbow (Swivel) |
| Inlet Connection | 3/4" Female Hose Thread (FHT) Swivel |
| Outlet Connection | 1/2" Compression (Fits .690" - .710" OD Tubing) |
| Operating Pressure | 0 - 60 PSI (Optimal: 20-30 PSI) |
| Material | High-Impact ABS Plastic |
| MPN | CSEL 700 |
Install your system start in minutes.
Step 1: Connect to Source
Ensure the rubber hose washer is seated inside the swivel nut. Screw the swivel nut onto your faucet, timer, pressure regulator, or filter. Hand-tighten until snug.
Step 2: Prep Tubing
Cut your 1/2" poly tubing squarely. Check that the end is smooth and clean.
Tip: Warm the tubing end in the sun or hot water to soften it before installation.
Step 3: Insert Tubing
Push the 1/2" tubing into the compression end of the elbow. Rock it back and forth while pushing firmly until it passes the internal resistance ring (approx. 1/2" to 3/4" deep).
Ensure this fitting fits your components:
Build a reliable head assembly with these parts:
Jun 10th 2026
Jun 9th 2026
Jun 8th 2026
Jun 4th 2026
